this post was submitted on 11 Nov 2024
994 points (98.3% liked)
Programming Humor
2736 readers
66 users here now
Related Communities [email protected] [email protected] [email protected] [email protected]
Other Programming Communities [email protected] [email protected] [email protected] [email protected] [email protected] [email protected] [email protected]
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
MasterCAM blows absolutely every open-source solution out of the water. It isn't even a competition. In this case, it is actually cheaper to buy their really expensive and restrictive license, because in the end you save a near immeasurable amount of time in modeling, drafting, programming, and production. The fee CAD programs that can even support a postprocessing operation (becoming closer to a real CAM solution) are really bad at it and the toolpaths are far from ideal.
That sounds really specific.
It is, but MasterCAM is also the primary workhorse for a large global industry, so I wouldn't say that it is insignificant by any means.